Puggle

A A A A Author Topic: Rae-San Ignition - Advice Needed on Mounting Locations/Options  (Read 73 times)

Barocca

I am just completing installation of a Rae-San V3.0 Hall Effect Full Kit, as shown below, on my 1978 CX500.  Rayman, in his installation instructions, says that there are many options for installing the driver modules, and shows one possible arrangement (also shown below).  I have tried the arrangement shown, and have found that there is insufficient room to fit my seat without crushing the wiring emerging from the modules.  The upshot of this is that I'm seeking advice about how others have mounted these modules, and any tips and tricks. 

 


Website and forum protected by
 STOP FORUM SPAM       Bad Behavior      Stop Spam Harvesters, Join Project Honey Pot      Let's Encrypt

Puggle